Post by universalexports on May 9, 2012 21:57:45 GMT -5
well I was installing my fantastic fan, and you have to run the wires as well.
this is what I found out, you can drill a hole through the 1x2 inside your vent hole the one on the street side,
I found out if you remove the fuse box, (mine is in the cabinet next to the hole) there is a slot cut in the wall, about 4 inches by 1/2 inch, and I was able to stick a small piece of wire through the hole I drilled and fish it out of the 4 inch hole behind the fuse box.
then tape the wires to the wire I fished through the hole and pull your wires through.
this allows you to wire in a 12 volt converter in the cabinet without having to remove or cut into the roof or wall, just an idea someone might need to avoid tearing into the walls or roof.
this is what I found out, you can drill a hole through the 1x2 inside your vent hole the one on the street side,
I found out if you remove the fuse box, (mine is in the cabinet next to the hole) there is a slot cut in the wall, about 4 inches by 1/2 inch, and I was able to stick a small piece of wire through the hole I drilled and fish it out of the 4 inch hole behind the fuse box.
then tape the wires to the wire I fished through the hole and pull your wires through.
this allows you to wire in a 12 volt converter in the cabinet without having to remove or cut into the roof or wall, just an idea someone might need to avoid tearing into the walls or roof.