|
|
Post by oldcarbuff on Jan 16, 2013 15:05:39 GMT -5
Looking for this weather strip for windows on 64 Shasta. Any help is appreciated. Mark Attachments:
|
|
|
|
Post by pathfinder3081 on Jan 16, 2013 15:28:22 GMT -5
Hey Mark,
Is that the strip at the bottom of the roll out window? The bottom window lip shuts against it. If it is , good luck. You can get the top drip cap stuff at VTS, but I have not seen the bottom seal anywhere.
I use the same strip on the bottom as on the top. I just trimmed off the excess. It not as good as the original stuff for sure. But it's my alternate.
|
|
|
|
Post by schweetcruisers on Jan 16, 2013 15:33:44 GMT -5
How much do you need? I have some N.O.S. weatherstrip I found in a old rv repair shop. Don't want to sell it all since I don't know if I'll do another. BTW it's a PTA to install!!
|
|
|
|
Post by oldcarbuff on Jan 16, 2013 15:38:43 GMT -5
Schweet- It is the seal at both the top and bottom. I need to do several windows so probably 15 ft. The bottom and top on this window appear to be the same. The product from vts is the 7/8 " wide? I thought about using it.
Mark
|
|
|
|
Post by schweetcruisers on Jan 16, 2013 15:39:21 GMT -5
Here is the stuff I have, its slightly different.  |
|
|
|
Post by oldcarbuff on Jan 16, 2013 20:14:14 GMT -5
do you know how the Jalousie Header & Sill Seal from VTS fits?
|
|
|
|
Post by capnjonny on Jan 16, 2013 21:26:21 GMT -5
don't know if everyone knows about these guys but they can make any molding and might have you pattern in stock since they made moldings for So cal sailboats in the 60's and probably for the trailer builders . www.wefcorubber.com/Check them out. If your profile is a new one you have to pay for the extruder and there is a minimum order but it could work out. |
|
|
|
Post by pathfinder3081 on Jan 17, 2013 8:55:58 GMT -5
Yeah, that looks like the good stuff Schweet. It has the raise ribs on the contact area. I see this style on the interior top, bottom and sides. (or somehthing very similar on my 71) It creates the complete sealed contact when the window is cranked in and snug. The one window I have rebuilt had decent interior strips except for the bottom. I replaced the top exterior drip strip and bottom only. It's a real pain to clean out the old stuff too. Santa Claus brought me a new Dremel tool for Christmas. I really think that it will come in handy renovating the next one. Attachments:
|
|
