|
Post by lusterbunny on Jul 13, 2011 22:39:04 GMT -5
i have a airflyte and I have water damage under the front and rear windows. I want to repair this area (remove the rot) but I want to keep all the good panels as it has a beautiful grain. What is the best way to replace a few panels, should I go from the outside or inside? I also want to replace the wiring which is old and crumbly will going form the outside make this easier or should I run wires inside cabinets etc? Will I also have to remove all the cabinets stove, etc?
|
|
vikx
3K Post Member
Posts: 3,556
|
Post by vikx on Jul 14, 2011 1:45:15 GMT -5
It's rare that a few panels need replacing. There is rot in them thar walls.... to do just a patch, inside is easier.
Also, are you sure the wiring is bad? My oldest trailer is a 1952 with wiring still in good condition. Most of the time, if the wiring is original, it is safe. It's when POs modify that causes trouble. Repairing original wiring is easier with the walls open, in or out. Adding new can be done thru the cupboards it you can get to the old to begin with.
If you have pictures of the panels and wiring, members will be able to help with your questions. Also, if you are not experienced in electrical work, it would be wise to consult a licensed electrician.
|
|
|
Post by lusterbunny on Jul 14, 2011 14:26:34 GMT -5
I am sure that I may need to replace more of the fram than what is under the panels, which I am fine with, but I want to preserve the wood panels that are perfect because the wood grain is so nice. That is why I was wondering if going from the outside would preserve the interior wood. I know the PO did some modifications, so that is why I thought it might be best to replace wire, plus when I removed the side lights to clean them the casing on the wire was pretty much gone. cheers rain
|
|