Outside Corner Extrusions

[sfhurst]

I am looking for a source to replace the aluminum extrusion that protect/finishes the four outside corners of my 1958 Shasta AirFlyte. The front ones are in good shape, but a previous owner replaced the replaced the rear ones (probably due to damage to the rear of the trailer) with a length of 1" aluminum angle crudely bent to fit the curve. Any ideas or source for a better replacement.

[Atomic Addiction]

I'm not sure that this is the right size or profile but it is a start...

teardropparts.com/sub-pages/teardrop-moldings.htm

Look at the DRIP RAIL MOLDINGS on that page.

If not we will help you look for another solution.

Brian

[sfhurst]

Thanks for the reply, and for the suggested source. Actually the TOP EDGE MOLDING may be a better fit. THANKS A BUNCH for the source!!

[Atomic Addiction]

No problem. Let us know how it turns out.

Brian